sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Bakker, L.

Normalized to: Bakker, L.

5 article(s) in total. 9 co-authors, from 1 to 5 common article(s). Median position in authors list is 3,0.

[1]  oai:arXiv.org:1108.5430  [pdf] - 425219
THACO, a Test Facility for Characterizing the Noise Performance of Active Antenna Arrays
Comments: 4 pages, 6 figures. Official Publication: Microwave Journal; Proc. of European Microwave Week (EuMW2011), October 9th-14th, 2011
Submitted: 2011-08-27, last modified: 2011-10-13
This paper discusses an outdoor test facility for the noise characterization of active antenna arrays, using measurement results of array noise temperatures in the order of 50 K for a number of small aperture arrays. The measurement results are obtained by a Y-factor method with hot and a cold noise sources, with an absorber at room temperature as the hot load and the cold sky as the cold load. The effect of shielding the arrays by the test facility, with respect to noise and RFI from the environment, will also be discussed.
[2]  oai:arXiv.org:1110.2996  [pdf] - 425314
Numerical Results for the System Noise Temperature of an Aperture Array Tile and Comparison with Measurements
Comments: ASTRON report
Submitted: 2011-10-13
The purpose of this report is to document the noise performance of a complex beamforming array antenna system and to characterize the recently developed noise measurement facility called THACO, which was developed at ASTRON. The receiver system includes the array antenna of strongly coupled 144 TSA elements, 144 Low Noise Amplifiers (LNAs) (Tmin =35-40K) and the data recording/storing facilities of the initial test station that allow for off-line digital beamforming. The primary goal of this study is to compare the measured receiver noise temperatures with the simulated values for several practical beamformers, and to predict the associated receiver noise coupling contribution, antenna thermal noise and ground noise pick-up (due to the back radiation).
[3]  oai:arXiv.org:1108.5433  [pdf] - 1083661
Experimental Results of the Sensitivity of a Low Noise Aperture Array Tile for the SKA
Comments: 6 pages, 6 figures, accepted for publication in the IEEE Transactions on Antennas and Propagation
Submitted: 2011-08-27
Aperture arrays have been studied extensively for application in the next generation of large radio telescopes for astronomy, requiring extremely low noise performance. Prototype array systems need to demonstrate the low noise potential of aperture array technology. This paper presents noise measurements for an Aperture Array tile of 144 dual-polarized tapered slot antenna (TSA) elements, originally built and characterized for use as a Phased Array Feed for application in an L-band radio astronomical receiving system. The system noise budget is given and the dependency of the measured noise temperatures on the beam steering is discussed. A comparison is made of the measurement results with simulations of the noise behavior using a system noise model. This model includes the effect of receiver noise coupling, resulting from a changing active reflection coefficient and array noise contribution as a function of beam steering. Measurement results clearly demonstrate the validity of the model and thus the concept of active reflection coefficient for the calculation of effective system noise temperatures. The presented array noise temperatures, with a best measured value of 45 K, are state-of-the-art for room temperature aperture arrays in the 1 GHz range and illustrate their low noise potential.
[4]  oai:arXiv.org:0912.0093  [pdf] - 31205
Apertif - the focal-plane array system for the WSRT
Comments: Presented at Widefield Science and Technology for the SKA, SKADS Conference 2009, Chateau de Limelette, Belgium, 4-6 novemer 2009; 7 pages
Submitted: 2009-12-01
We describe a focal plane array (FPA) system, called Apertif, that is being developed for the Westerbork Synthesis Radio Telescope (WSRT). The aim of Apertif is to increase the instantaneous field of view of the WSRT by a factor of 37 and its observing bandwidth to 300 MHz with high spectral resolution. This system will turn the WSRT into an effective survey telescope with scientific applications such as deep imaging surveys of the northern sky of HI and OH emission, of the polarised continuum and efficient searches for pulsars and transients. Such surveys will detect the HI in more than 100,000 galaxies out to z = 0.4, will allow to determine the detailed structure of the magnetic field of the Galaxy, and will discover more than 1,000 pulsars. We present experimental results obtained with a prototype FPA installed in one of the WSRT dishes. These results demonstrate that FPAs do have the performance that is required to make all these surveys possible.
[5]  oai:arXiv.org:0806.0234  [pdf] - 13137
APERTIF, a focal plane array for the WSRT
Comments: 7 pages, 6 figures. Presented at "The Evolution of Galaxies through the Neutral Hydrogen Window", Feb 1-3, 2008, Arecibo Observatory, Puerto Rico. High resolution versions of figures available in jpg-format
Submitted: 2008-06-02
In this paper we describe a focal plane array (FPA) prototype, based on Vivaldi elements, developed for the Westerbork Synthesis Radio Telescope (WSRT) to increase its instantaneous field of view by a factor 25 and double its current bandwidth. This prototype is the first step in a project that has the ambition to equip most of the WSRT antennas with FPAs to improve the survey speed of the telescope. Examples of scientific applications are surveys of the northern sky in polarised continuum and HI emission, and efficient searches for pulsars and transients.