The Coronal Multi-channel Polarimeter (CoMP) obtains daily full-Sun above-the-limb coronal observations in linear polarization, allowing for the first time a diagnostic of the coronal magnetic field direction in quiescent prominence cavities. We find that these cavities consistently possess a characteristic "lagomorphic" signature in linear polarization indicating twist or shear extending up into the cavity above the neutral line. We demonstrate that such a signature may be explained by a magnetic flux-rope model, a topology with implications for solar eruptions. We find corroborating evidence for a flux rope structure in the pattern of concentric rings within cavities seen in CoMP line-of-sight velocity.

It is well known that there is temporal relationship between coronal mass ejections (CMEs) and associated flares. The duration of the acceleration phase is related to the duration of the rise phase of a flare. We investigate CMEs associated with slow long duration events (LDEs), i.e. flares with the long rising phase. We determined the relationships between flares and CMEs and analyzed the CME kinematics in detail. The parameters of the flares (GOES flux, duration of the rising phase) show strong correlations with the CME parameters (velocity, acceleration during main acceleration phase and duration of the CME acceleration phase). These correlations confirm the strong relation between slow LDEs and CMEs. We also analyzed the relation between the parameters of the CMEs, i.e. a velocity, an acceleration during the main acceleration phase, a duration of the acceleration phase, and a height of a CME at the end of the acceleration phase. The CMEs associated with the slow LDEs are characterized by high velocity during the propagation phase, with the median equal 1423 km/s. In half of the analyzed cases, the main acceleration was low (a<300 m/s^2), which suggests that the high velocity is caused by the prolongated acceleration phase (the median for the duration of the acceleration phase is equal 90 minutes). The CMEs were accelerated up to several solar radii (with the median 7 Rsun), which is much higher than in typical impulsive CMEs. Therefore, slow LDEs may potentially precede extremely strong geomagnetic storms. The analysis of slow LDEs and associated CMEs may give important information for developing more accurate space weather forecasts, especially for extreme events.

As it was shown by many authors, a slow decrease in X-rays observed during the decay phase of long duration flares (LDE) can be explained only by a magnetic reconnection and energy release ceaselessly ongoing in the coronal part of a flare. Using RHESSI data we try to answer two following questions. How effective are these processes at the LDEs decay phase and how can precisely the energy release rate be calculated based on these data? To answer the questions images of the selected LDEs during their decay phase were reconstructed. Physical parameters of flare coronal sources obtained from image spectral analysis allowed us to study the efficiency of the energy release process. We also examined terms included in the energy equation to find out what is the accuracy of determination of each term.

Context: The Yohkoh/HXT observations of Long Duration Events (LDEs) showed that the HXR emission (14-23 keV) is present for tens of minutes after flare maximum. Hence, some heating process is expected to exist during that time. The better energy resolution of RHESSI compared to HXT allow us to analyse LDEs in more comprehensive way. Aims: We selected three LDEs observed by RHESSI to answer the questions how long HXR emission can be present, where it is emitted, what is its nature and how much energy should be released to sustain the emission. Methods: We used RHESSI data to reconstruct images of the selected flares with an energy resolution as good as 1 keV. Next we estimated physical parameters of HXR sources through imaging spectroscopy. The physical parameters obtained were then used to calculate the energy balance of the observed sources. Results: We found that HXR thermal emission can be present for many hours after LDE flare maximum. The emission comes from large and hot loop-top sources. The total energy that must be released to sustain the emission of the sources is as high as 10^31 erg.

We analyse the observational characteristics for a set of Long Duration Events (LDE) using Reuven Ramaty High Energy Solar Spectroscopic Imager (RHESSI). Excellent energy resolution (1 keV) of HXR images reconstructed with RHESSI allowed us to perform imaging spectroscopy of coronal loop top sources (LTS) observed for hours after maximum of the flare. We found that the sources are large structures. The diameter of an LTS is changing with time and energy. High temperature component can be observed for few dozen hours after the maximum. For some time intervals clear non-thermal component was observed in spectra, but there was no significant footpoint emission at that time. All thermal and non-thermal emissions originate from the LTS. The obtained observational characteristics were used in calculating the energy balance within LTS, which are presented in Kolomanski, 2011 (this issue).

Slow Long Duration Events (SLDEs) are flares characterized by long duration of rising phase. In many such cases impulsive phase is weak with lack of typical short-lasting pulses. Instead of that smooth, long-lasting Hard X-ray (HXR) emission is observed. We analysed hard X-ray emission and morphology of six selected SLDEs. In our analysis we utilized data from RHESSI and GOES satellites. Physical parameters of HXR sources were obtained from imaging spectroscopy and were used for the energy balance analysis. Characteristic time of heating rate decrease, after reaching its maximum value, is very long, which explains long rising phase of these flares.

In a standard method of determining electron density for soft X-ray (SXR) flare kernels it is necessary to assume what is the extension of a kernel along the line of sight. This is a source of significant uncertainty of the obtained densities. In our previous paper (Bak-Steslicka and Jakimiec, 2005) we have worked out another method of deriving electron density, in which it is not necessary to assume what is the extension of a kernel along the line of sight. The point is that many flares, during their decay phase, evolve along the sequence of steady-state models [quasi-steady-state (QSS) evolution] and then the scaling law, derived for steady-state models, can be used to determine the electron density. The aim of the present paper is: (1) to improve the two methods of density determination, (2) to compare the densities obtained with the two methods. We have selected a number of flares which showed QSS evolution during the decay phase. For these flares the electron density, N, has been derived by means of standard method and with our QSS method. Comparison of the N values obtained with the two different methods allowed us: (1) to test the obtained densities, (2) to evaluate the volume filling factor of the SXR emitting plasma. Generally, we have found good agreement (no large systematic difference) between the values of electron density obtained with the two methods, but for some cases the values can differ by a factor up to 2. For most flare kernels estimated filling factor turned out to be about 1, near the flare maximum.

It is well known, that there is temporal relationship between CMEs and associated flares. The duration of the acceleration phase is related to the duration of the rise phase of a flare. We investigated CMEs associated with long duration flares of slow rise phase (slow LDE). These CMEs are characterized by high velocity (v>1000 km/s) during the propagation phase and low average acceleration during the main, prolongated, acceleration phase. The CMEs are accelerated until the height $> 5 R_\odot$, which is higher value than in typical impulsive CMEs. CMEs associated with slow LDEs have characteristics of both classes of CMEs, i.e. CMEs associated with flares and CMEs associated with eruptive prominences.