Previous work on the quasar mass-luminosity plane indicates the possibility that quasars of the same central black hole mass might follow a common evolutionary track, independent of the properties of the host galaxy. We consider two simple models for the evolution of individual quasars. Requiring these tracks to lie within the observed quasar locus at all redshifts strongly constrains the model parameters, but does allow some solutions. These solutions include a family of tracks with similar shape but different initial masses that might match the observed quasar distributions at all redshifts z < 2.0. This family of solutions is characterized by short (1-2 Gyr) lifetimes, a duty cycle in which the quasar is on at least 25% of the time, and a rapid decline in Eddington ratio, perhaps with L/L_Edd ~ t^-6 or steeper.

In inflationary models, gravitational waves are produced and generate B-type polarization in the CMB. Since B polarization is only generated by gravity waves it does not suffer from the cosmic variance. A perfect decomposition of the CMB into B-modes and E-modes would require data from the entire sky, which in practice is not possible because of the foreground contaminants. This leads to mixing of E polarization into B, which introduces cosmic variance conta- mination of B polarization and reduces sensitivity to gravity wave amplitude even in absence of detector noise. We present numerical results for the uncertainty in the tensor-to-scalar ratio using the Fisher matrix formalism for various resolutions, using foreground models based on dust maps and assuming 90 GHz operating frequency. We find that the usual scaling delta(T/S) ~ f_sky^(-1/2) is significantly degraded and becomes delta(T/S) ~ f_sky^(-2) for f_sky>0.7. This dependence is affected only weakly by the choice of sky cuts. To achieve a T/S=10^(-3) detection at 3 sigma one needs to observe 15% of the sky as opposed to naive expectation of 0.3%. To prevent contamination over this large sky area at required level one must be able to remove polarized dust emission at or better than 0.1% of unpolarized intensity, assuming the cleanest part of the sky has been chosen. To achieve T/S=10^(-4) detection at 3 sigma one needs to observe 70% of the sky, which is only possible if dust emission is removed everywhere over this region at 0.01% level. Reaching T/S=10^(-2) should be easier: 1% of the sky is needed over which polarized emission needs to be removed at 1% of total intensity if the cleanest region is chosen. These results suggest that foreground contamination may make it difficult to achieve levels below T/S=10^(-3). (abridged)