Imaging Atmospheric Cherenkov Telescopes (IACTs) need imaging optics with large apertures to map the faint Cherenkov light emitted in extensive air showers onto their image sensors. Segmented reflectors fulfill these needs using mass produced and light weight mirror facets. However, as the overall image is the sum of the individual mirror facet images, alignment is important. Here we present a method to determine the mirror facet positions on a segmented reflector in a very direct way. Our method reconstructs the mirror facet positions from photographs and a laser distance meter measurement which goes from the center of the image sensor plane to the center of each mirror facet. We use our method to both align the mirror facet positions and to feed the measured positions into our IACT simulation. We demonstrate our implementation on the 4 m First Geiger-mode Avalanche Cherenkov Telescope (FACT).

For studying variable sources like blazars, it is crucial to achieve unbiased monitoring, either with dedicated telescopes in pointing mode or survey instruments. At TeV energies, the High Altitude Water Cherenkov (HAWC) observatory monitors approximately two thirds of the sky every day. It uses the water Cherenkov technique, which provides an excellent duty cycle independent of weather and season. The First G-APD Cherenkov Telescope (FACT) monitors a small sample of sources with better sensitivity, using the imaging air Cherenkov technique. Thanks to its camera with silicon-based photosensors, FACT features an excellent detector performance and stability and extends its observations to times with strong moonlight, increasing the duty cycle compared to other imaging air Cherenkov telescopes. As FACT and HAWC have overlapping energy ranges, a joint study can exploit the longer daily coverage given that the observatories' locations are offset by 5.3 hours. Furthermore, the better sensitivity of FACT adds a finer resolution of features on hour-long time scales, while the continuous duty cycle of HAWC ensures evenly sampled long-term coverage. Thus, the two instruments complement each other to provide a more complete picture of blazar variability. In this presentation, the first joint study of light curves from the two instruments will be shown, correlating long-term measurements with daily sampling between air and water Cherenkov telescopes. The presented results focus on the study of the variability of the bright blazars Mrk 421 and Mrk 501 during the last two years featuring various flaring activities.

Possible nature of strongly magnetized white dwarfs (SMWDs) is studied. It is shown that for relatively low values of the equatorial surface magnetic field $B\,\sim\,10^9\,-\,10^{11}$ G they can be good candidates for soft gamma-ray repeaters and anomalous X-ray pulsars (SGRs/AXPs). For the case of iron SMWDs the influence of a neutrinoless electron to positron conversion on the SGRs/AXPs luminosity is estimated.

We measure cross sections for residual nuclide formation in the mass range 6 < A < 97 caused by bombardment with protons and deuterons of 3.65 GeV/nucleon energy of enriched tin isotopes (112-Sn, 118-Sn, 120-Sn, 124-Sn). The experimental data are compared with calculations by the codes FLUKA, LAHET, CEM03, and LAQGSM03. Scaling behavior is observed for the whole mass region of residual nuclei, showing a possible multifragmentation mechanism for the formation of light products (6 < A < 31). Our analysis of the isoscaling dependence also shows a possible contribution of multifragmentation to the production of heavier nuclides, in the mass region 39 < A < 81.

We have analyzed the recent JINR measurements on nuclide production cross sections from interaction of 660 MeV proton beams with radioactive targets of enriched 129I (85% 129I and 15% 127I), 237Np, and 241Am with eleven different models, realized in eight transport codes and event-generators: LAHET (Bertini, ISABEL, INCL+ABLA, and INCL+RAL options), CASCADE, CEM95, CEM2k, LAQGSM+GEM2, CEM2k+GEM2, LAQGSM+GEMINI, and CEM2k+GEMINI. We found out that all these models have problems in a correct description of many of these cross sections, though some of these models describe very well most of the recent measurements done at GSI using inverse kinematics, as well as many other reactions. None of the tested here models is able to reproduce well all the JINR data and all of them should be further improved. Development of a better universal evaporation/fission model should be of a highest priority. We conclude that it is impossible to make a correct choice between fission and fragmentation reaction mechanisms analyzing only measurements on product cross sections; addressing this question would require analysis of two- or multi-particle correlation measurements.

Two NaI (85% 129-I and 15% 127-I) targets were exposed to a beam of 660-MeV protons. Cross sections for formation of 76 residual nuclei were obtained by the induced activity method. The results are compared with other experimental data on 127-I and theoretical calculations by eleven models contained in the codes LAHET3 (using the Bertini+Dresner, ISABEL+Dresner, INCL+Dresner, and INCL+ABLA options), CASCADE, CEM95, CEM2K, LAQGSM+GEM2, CEM2k+GEM2, LAQGSM+GEMINI, and CEM2k+GEMINI. Most of the models describe spallation products with masses close to the target reasonably well while the reliability of the codes differs greatly in the deep spallation and fission/fragmentation regions. The difficulties in describing products with A=40-80 by all of the codes tested here except for CEM2k+GEMINI and LAQGSM+GEMINI is related to the neglect of fission (and fragmentation) processes for targets as light as 129-I.