sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Abril-Melgarejo, V.

Normalized to: Abril-Melgarejo, V.

2 article(s) in total. 31 co-authors, from 1 to 2 common article(s). Median position in authors list is 19,0.

[1]  oai:arXiv.org:1701.01695  [pdf] - 1546343
Star formation driven galactic winds in UGC 10043
Comments: 14 pages, 12 figures, accepted for publishing in MNRAS
Submitted: 2017-01-06
We study the galactic wind in the edge-on spiral galaxy UGC 10043 with the combination of the CALIFA integral field spectroscopy data, scanning Fabry-Perot interferometry (FPI), and multiband photometry. We detect ionized gas in the extraplanar regions reaching a relatively high distance, up to ~ 4 kpc above the galactic disk. The ionized gas line ratios ([N ii]/Ha, [S ii]/Ha and [O i]/Ha) present an enhancement along the semi minor axis, in contrast with the values found at the disk, where they are compatible with ionization due to H ii-regions. These differences, together with the biconic symmetry of the extra-planar ionized structure, makes UGC 10043 a clear candidate for a galaxy with gas outflows ionizated by shocks. From the comparison of shock models with the observed line ratios, and the kinematics observed from the FPI data, we constrain the physical properties of the observed outflow. The data are compatible with a velocity increase of the gas along the extraplanar distances up to < 400 km/s and the preshock density decreasing in the same direction. We also observe a discrepancy in the SFR estimated based on Ha (0.36 Msun/yr ) and the estimated with the CIGALE code, being the latter 5 times larger. Nevertheless, this SFR is still not enough to drive the observed galactic wind if we do not take into account the filling factor. We stress that the combination of the three techniques of observation with models is a powerful tool to explore galactic winds in the Local Universe.
[2]  oai:arXiv.org:1602.01830  [pdf] - 1353704
Pipe3D, a pipeline to analyse integral field spectroscopy data: II. Analysis sequence and CALIFA dataproducts
Comments: 53 pages, 17 figures, accepted for publishing in RevMxAA
Submitted: 2016-02-03
We present Pipe3D, an analysis pipeline based on the FIT3D fitting tool, devel- oped to explore the properties of the stellar populations and ionized gas of Integral Field Spectroscopy data. Pipe3D was created to provide with coherent, simple to distribute, and comparable dataproducts, independently of the origin of the data, focused on the data of the most recent IFU surveys (e.g., CALIFA, MaNGA, and SAMI), and the last generation IFS instruments (e.g., MUSE). Along this article we describe the different steps involved in the analysis of the data, illustrating them by showing the dataproducts derived for NGC 2916, observed by CALIFA and P-MaNGA. As a practical use of the pipeline we present the complete set of dataproducts derived for the 200 datacubes that comprises the V500 setup of the CALIFA Data Release 2 (DR2), making them freely available through the network (ftp://ftp.caha.es/CALIFA/dataproducts/DR2/Pipe3D). Finally, we explore the hypothesis that the properties of the stellar populations and ionized gas of galaxies at the effective radius are representative of the overall average ones, finding that this is indeed the case.