The influence of microlensing in the profiles of the emission lines generated in a biconical geometry is discussed. Microlensing amplification in this anisotropic model is not directly related to the bicone's intrinsic size but depends on the orientation of the bicone axis and on the cone aperture. The orientation of the projected bicone with respect to the shear of the magnification pattern can induce very interesting effects, like the quasi-periodic enhancements of the red/blue part of the emission line profile or the lack of correlation between the broad line region (BLR) and continuum light curves of QSOs. The emission line profiles of a BLR moving in a high caustic concentration exhibit sharp features that are well defined in wavelength. These features (spikes) correspond to the scanning of the kinematics of the BLR by the caustic clusters. The biconical model can qualitatively reproduce with a transversal (with respect to the shear) movement of the BLR, the recurrent blue-wing enhancement detected in the emission line profile of the A image of the quasar lensed system SDSS J1004+4112. The probability of observing this repetitive event is almost a 2% for a fraction of matter in stars of a 5%. This result would make plausible the detection of the spectral variability in SDSS J1004+4112 under the hypothesis of microlensing of a bicone.

The observed enhancement of the Fe K$\alpha$ line in three gravitationally lensed QSOs (MG J0414+0534, QSO 2237+0305, H1413+117) is interpreted in terms of microlensing, even when equivalent X-ray continuum amplification is not observed. In order to interpret these observations, first we studied the effects of microlensing on quasars spectra, produced by straight fold caustic crossing over standard relativistic accretion disk. The disk emission was analyzed using the ray tracing method, considering Schwarzschild and Kerr metrics. When the emission is separated in two regions (an inner disk corresponding to the Fe K$\alpha$ line and an outer annulus corresponding to the continuum, or vice-versa) we find microlensing events which enhance the Fe K$\alpha$ line without noticeable amplification of the X-ray continuum, but only during a limited time interval. Continuum amplification is expected if a complete microlensing event is monitored. Second, we studied a more realistic case of amplification by caustic magnification pattern. In this case we could satisfactorily explain the observations if the Fe K$\alpha$ line is emitted from the innermost part of the accretion disk, while the continuum is emitted from a larger region. Also, we studied the chromatic effects of microlensing, finding that the radial distribution of temperature in the accretion disk, combined with microlensing itself, can induce wavelength dependent variability of $\sim$ 30% for microlenses with very small masses. All these results show that X-ray monitoring of gravitational lenses is a well suited method for studying of the innermost structure of AGN accretion disks.

We report on an observing campaign in March 2001 to monitor the brightness of the later arriving Q0957+561 B image in order to compare with the previously published brightness observations of the (first arriving) A image. The 12 participating observatories provided 3543 image frames which we have analyzed for brightness fluctuations. From our classical methods for time delay determination, we find a 417.09 +/- 0.07 day time delay which should be free of effects due to incomplete sampling. During the campaign period, the quasar brightness was relatively constant and only small fluctuations were found; we compare the structure function for the new data with structure function estimates for the 1995--6 epoch, and show that the structure function is statistically non-stationary. We also examine the data for any evidence of correlated fluctuations at zero lag. We discuss the limits to our ability to measure the cosmological time delay if the quasar's emitting surface is time resolved, as seems likely.

We discuss the effects of microlensing on the broad emission lines (BELs) of QSOs in the light of recent determinations of the size of the broad line region (BLR) and its scaling with QSO luminosity. Microlensing by star-sized objects can produce significant amplifications in the BEL of some multiple-imaged QSOs, and could be very relevant for high-ionization lines. We have identified a group of ten gravitational lens systems (30% of the selected sample) in which microlensing could be observed. Using standard kinematic models for AGNs, we have studied the changes induced in the line profile by a microlens located at different positions with respect to the center of the BLR. We found that microlensing could produce important effects such as the relative enhancement of different parts of the line profile or the displacement of the peak of the line. The study of BEL profiles of different ionization in a microlensed QSO image could be an alternative method for probing the BLR structure and size.

An observing campaign with 10 participating observatories has undertaken to monitor the optical brightness of the Q0957 gravitationally lensed quasar for 10 consecutive nights in January 2000. The resulting A image brightness curve has significant brightness fluctuations and makes a photometric prediction for the B image light curve for a second campaign planned for 12-21 March 2001. The ultimate purpose is to determine the gravitational lens time delay to a fraction of an hour, and to seek evidence for rapid microlensing.

Photometric optical data of QSO 0957+561 covering the period 1984-99 are analyzed to discern between the two values of the time delay (417 and 424 days) mostly accepted in the recent literature. The observations, performed by groups from three different institutions-Princeton University, Harvard-Smithsonian Center for Astrophysics, and Instituto de Astrofisica de Canarias-and including new unpublished 1998-9 data from the IAC80 Telescope, were obtained in five filters (V, R, I, g, and r). The different light curves have been divided into observational seasons and two restriction have been applied to better calculate the time delay: (i) points with a strange photometric behavior have been removed; and (ii) data sets without large gaps have been selected. Simulated data were generated to test several numerical methods intended to compute the time delay. The methods giving the best results-the discrete correlation function, delta-square, z-transformed discrete correlation function, and linear interpolation-were then applied to real data. A first analysis of the 23 different time delays derived from each technique shows that the time delay must be into the interval 420-424 days. From our statistical study, a most probable value of 422.6 +/- 0.6 days is inferred.