sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Ševeček, P.

Normalized to: Ševeček, P.

4 article(s) in total. 12 co-authors, from 1 to 3 common article(s). Median position in authors list is 1,0.

[1]  oai:arXiv.org:1908.03248  [pdf] - 1962340
Impacts into rotating targets: angular momentum draining and efficient formation of synthetic families
Comments: Accepted for publication in A&A
Submitted: 2019-08-08
About 10% of the observed asteroids have rotational periods lower than P = 3 h and they seem to be relatively close to the spin barrier. Yet, the rotation has often been neglected in simulations of asteroid collisions. To determine the effect of rotation, we perform a large number of SPH/N-body impact simulations with rotating targets. We developed a new unified SPH/N-body code with self-gravity, suitable for simulations of both fragmentation phase and gravitational reaccumulation. The code has been verified against previous ones (Benz and Asphaug 1994), but we also tested new features, e.g. rotational stability, tensile stability, etc. Using the new code, we ran simulations with D_pb = 10 km and 100 km monolithic targets and compared synthetic asteroid families created by these impacts with families corresponding to non-rotating targets. The rotation affects mostly cratering events at oblique impact angles. The total mass ejected by these collision can be up to five times larger for rotating targets. We further compute the transfer of the angular momentum and determine conditions under which impacts accelerate or decelerate the target. While individual cratering collisions can cause both acceleration and deceleration, the deceleration prevails on average, collisions thus cause a systematic spin-down of asteroid population.
[2]  oai:arXiv.org:1803.10666  [pdf] - 1932611
SPH/N-body simulations of small (D = 10 km) asteroidal breakups and improved parametric relations for Monte-Carlo collisional models
Comments: Accepted to Icarus
Submitted: 2018-03-28
We report on our study of asteroidal breakups, i.e. fragmentations of targets, subsequent gravitational reaccumulation and formation of small asteroid families. We focused on parent bodies with diameters $D_{\rm pb} = 10$ km. Simulations were performed with a smoothed-particle hydrodynamics (SPH) code combined with an efficient N-body integrator. We assumed various projectile sizes, impact velocities and impact angles (125 runs in total). Resulting size-frequency distributions are significantly different from scaled-down simulations with $D_{\rm pb} = 100$ km targets (Durda et al., 2007). We derive new parametric relations describing fragment distributions, suitable for Monte-Carlo collisional models. We also characterize velocity fields and angular distributions of fragments, which can be used as initial conditions for N-body simulations of small asteroid families. Finally, we discuss a number of uncertainties related to SPH simulations.
[3]  oai:arXiv.org:1605.06959  [pdf] - 1451906
Obliquity dependence of the tangential YORP
Comments: Accepted for publication in A&A
Submitted: 2016-05-23
Context. Tangential YORP is a thermophysical effect that can alter the rotation rate of asteroids and is distinct from the "normal" YORP effect, but to date has only been studied for asteroids with zero obliquity. Aims. The tangential YORP force produced by spherical boulders on the surface of an asteroid with an arbitrary obliquity is studied. Methods. A finite element method is used to simulate heat conductivity inside a boulder, to find the recoil force experienced by it. Then an ellipsoidal asteroid uniformly covered by such boulders is considered and the torque is numerically integrated over its surface. Results. Tangential YORP is found to operate on non-zero obliquities and decreases by a factor of 2 for increasing obliquity.
[4]  oai:arXiv.org:1504.00566  [pdf] - 1232154
The thermal emission from boulders on (25143) Itokawa and general implications for the YORP effect
Comments: Accepted for publication in MNRAS
Submitted: 2015-04-02
Infrared radiation emitted from an asteroid surface causes a torque that can significantly affect rotational state of the asteroid. The influence of small topographic features on this phenomenon, called the YORP effect, seems to be of utmost importance. In this work, we show that a lateral heat diffusion in boulders of suitable sizes leads to an emergence of a local YORP effect which magnitude is comparable to the YORP effect due to the global shape. We solve a three-dimensional heat diffusion equation in a boulder and its surroundings by the finite element method, using the FreeFem++ code. The contribution to the total torque is inferred from the computed temperature distribution. Our general approach allows us to compute the torque induced by a realistic irregular boulder. For an idealized boulder, our result is consistent with an existing one-dimensional model. We also estimated (and extrapolated) a size distribution of boulders on (25143) Itokawa from close-up images of its surface. We realized that topographic features on Itokawa can potentially induce a torque corresponding to a rotational acceleration of the order 10^-7 rad day^-2 and can therefore explain the observed phase shift in light curves.