sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Čalogović, Jaša

Normalized to: Čalogović, J.

2 article(s) in total. 18 co-authors, from 1 to 2 common article(s). Median position in authors list is 5,5.

[1]  oai:arXiv.org:1801.07473  [pdf] - 1648832
Drag-Based Ensemble Model (DBEM) for Coronal Mass Ejection Propagation
Comments: 15 pages, 8 figures
Submitted: 2018-01-23
The drag-based model (DBM) for heliospheric propagation of coronal mass ejections (CMEs) is a widely used analytical model which can predict CME arrival time and speed at a given heliospheric location. It is based on the assumption that the propagation of CMEs in interplanetary space is solely under the influence of magnetohydrodynamical drag, where CME propagation is determined based on CME initial properties as well as the properties of the ambient solar wind. We present an upgraded version, covering ensemble modelling to produce a distribution of possible ICME arrival times and speeds, the drag-based ensemble model (DBEM). Multiple runs using uncertainty ranges for the input values can be performed in almost real-time, within a few minutes. This allows us to define the most likely ICME arrival times and speeds, quantify prediction uncertainties and determine forecast confidence. The performance of the DBEM is evaluated and compared to that of ensemble WSA-ENLIL+Cone model (ENLIL) using the same sample of events. It is found that the mean error is $ME=-9.7$ hours, mean absolute error $MAE=14.3$ hours and root mean square error $RMSE=16.7$ hours, which is somewhat higher than, but comparable to ENLIL errors ($ME=-6.1$ hours, $MAE=12.8$ hours and $RMSE=14.4$ hours). Overall, DBEM and ENLIL show a similar performance. Furthermore, we find that in both models fast CMEs are predicted to arrive earlier than observed, most probably owing to the physical limitations of models, but possibly also related to an overestimation of the CME initial speed for fast CMEs.
[2]  oai:arXiv.org:1712.07301  [pdf] - 1606348
Using Forbush decreases to derive the transit time of ICMEs propagating from 1 AU to Mars
Comments:
Submitted: 2017-12-19
The propagation of 15 interplanetary coronal mass ejections (ICMEs) from Earth's orbit (1 AU) to Mars (~ 1.5 AU) has been studied with their propagation speed estimated from both measurements and simulations. The enhancement of magnetic fields related to ICMEs and their shock fronts cause the so-called Forbush decrease, which can be de- tected as a reduction of galactic cosmic rays measured on-ground. We have used galactic cosmic ray (GCR) data from in-situ measurements at Earth, from both STEREO A and B as well as GCR measurements by the Radiation Assessment Detector (RAD) instrument onboard Mars Science Laboratory (MSL) on the surface of Mars. A set of ICME events has been selected during the periods when Earth (or STEREO A or B) and Mars locations were nearly aligned on the same side of the Sun in the ecliptic plane (so-called opposition phase). Such lineups allow us to estimate the ICMEs' transit times between 1 and 1.5 AU by estimating the delay time of the corresponding Forbush decreases measured at each location. We investigate the evolution of their propagation speeds before and after passing Earth's orbit and find that the deceleration of ICMEs due to their interaction with the ambient solar wind may continue beyond 1 AU. We also find a substantial variance of the speed evolution among different events revealing the dynamic and diverse nature of eruptive solar events. Furthermore, the results are compared to simulation data obtained from two CME propagation models, namely the Drag-Based Model and ENLIL plus cone model.